Viking Professional VEDO266SS User Manual page 17

B B e e f f o o r r e e s s t t a a r r t t i i n n g g t t h h e e S S e e l l f f - - C C l l e e a a n n c c y y c c l l e e : :
1. Remove the oven racks, rack supports, and any other items/utensils
from the oven. The high heat generated during the cleaning cycle can
discolor, warp, and damage these items. Do not use foil or liners in the
oven. During the Self-Clean cycle foil can burn or melt and damage the
oven surface.
2. Wipe off any large spills from the oven bottom and sides. Never use
oven cleaners inside a self-cleaning oven or on raised portions of the
door.
3. Some areas of the oven must be cleaned by hand before the cycle
begins. Soils in these areas will be baked on and very difficult to clean if
not removed first. Clean the door up to the gasket, the door frame, and
up to 2 inches inside the frame with detergent and hot water. Rinse
thoroughly and dry.
T T o o s s t t a a r r t t t t h h e e S S e e l l f f - - C C l l e e a a n n c c y y c c l l e e : :
1. Close the door completely.
2. Turn the oven selector knob clockwise to the self-clean mode.
3. Turn the temperature control knob past the clean setting until the knob
stops. At this time, the clean indicator light will come on. Within 30
seconds the automatic door latch engages and the oven indicator light
comes on. The oven indicator light will remain on until the oven reaches
the self-clean temperature and will then cycle on and off during the self-
clean cycle. When the oven reaches the elevated temperature needed
for self-clean, the door lock indicator light comes on.
4. The door lock indicator light will remain on until the self-clean is
completed or interrupted and the oven temperature drops to a safe
temperature. A complete cycle is approximately 3 1/2 hours with an
additional 30 minutes needed for the oven to cool down enough for the
door latch to disengage. N N O O T T E E : A fan noise will be heard during teh
self-clean cycle and will continue to run for the 3-1/2 hour duration of the
self-clean cycle.
5. When the cycle is completed, turn both the oven selector and
temperature control knob to the off position. When the oven has
completely cooled, open door and remove any ash from the oven
surfaces with a damp cloth.
32
T T o o s s t t o o p p t t h h e e s s e e l l f f - - c c l l e e a a n n c c y y c c l l e e : :
To cancel or interrupt the self-cleaning cycle, turn both the temperature
control knob and the oven function selector knob to "OFF". When the
oven temperature drops to a safe temperature, the automatic door latch will
release and the oven door can be opened. When the oven has completely
cooled, remove any ash from the oven surfaces with a damp sponge or
cloth.
R R e e p p l l a a c c i i n n g g I I n n t t e e r r i i o o r r O O v v e e n n L L i i g g h h t t s s
C C A A U U T T I I O O N N : : D D I I S S C C O O N N N N E E C C T T T T H H E E E E L L E E C C T T R R I I C C P P O O W W E E R R A A T T T T H H E E M M A A I I N N F F U U S S E E
O O R R C C I I R R C C U U I I T T B B R R E E A A K K E E R R B B E E F F O O R R E E R R E E P P L L A A C C I I N N G G B B U U L L B B . .
1. Unscrew glass light cover.
2. Use an oven mitt during bulb removal to protect
your hand in case the bulb breaks.
3. Replace the bulb with a 120 volt, 40 watt appliance
bulb.
4. Replace the light cover.
5. Reconnect power at the main fuse or circuit
breaker.
P P o o w w e e r r F F a a i i l l u u r r e e
Do not attempt to use during a power failure. Unit will not function.
33