Electrical Grounding Instructions - Viking Designer DMOR200SS Use & Care Manual

IMPORTANT–
ELECTRICAL GROUNDING
INSTRUCTIONS
This appliance must be grounded. In the event of an electrical short
circuit, grounding reduces risk of electric shock by providing an escape
wire for the electric current. This oven is equipped with a cord having a
grounding wire with a grounding plug. It must be plugged into a wall
receptacle that is properly installed and grounded in accordance with
the National Electrical Code and local codes and ordinances.
Improper use of the grounding plug can result in a risk of electric
shock.
Electrical Requirements
The oven is equipped with a 3-prong
grounding plug. Do not under any circum-
stances cut or remove the grounding pin
from the plug. Do not use an extension
cord. If the power supply cord is too short,
have a qualified electrician or serviceperson
install an outlet near the appliance.
The Power Supply Cord and plug must be
connected to a separate 120 Volt AC, 60
Hz, 15 Amp, or more branch circuit, single grounded receptacle. The
receptacle should be located inside the cabinet directly above the
Microwave Oven mounting location.
Note:
• If you have any questions about the grounding or electrical instruc-
tions, consult a qualified electrician or serviceperson.
• Neither Viking nor the dealer can accept any liability for damage to
the oven or personal injury resulting from failure to observe the cor-
rect electrical connection procedures.
Radio or TV Interference
Should there be any interference caused by the Built-in Microwave
Hood to your radio or TV, check that the Built-in Microwave Hood is on
a different electrical circuit, relocate the radio or TV as far away from
the oven as feasible or check position and signal of receiving antenna.
E
Please Read and Follow
WARNING
8