Electrical Grounding Instructions - Viking RVM320 Use And Care Manual

IMPORTANT–
ELECTRICAL GROUNDING
INSTRUCTIONS
This appliance must be grounded. In the event of an electrical short
circuit, grounding reduces risk of electric shock by providing an escape
wire for the electric current. This oven is equipped with a cord having a
grounding wire with a grounding plug. It must be plugged into a wall
receptacle that is properly installed and grounded in accordance with
the National Electrical Code and local codes and ordinances.
Improper use of the grounding plug can result in a risk of electric
shock.
Electrical Requirements
The oven is equipped with a 3-prong
grounding plug. DO NOT UNDER ANY
CIRCUMSTANCES CUT OR REMOVE THE
GROUNDING PIN FROM THE PLUG.
DO NOT USE AN EXTENSION CORD. If
the power supply cord is too short, have a
qualified electrician or serviceperson install
an outlet near the appliance.
The Power Supply Cord and plug must be connected to a separate
120 Volt AC, 60 Hz, 15 Amp, or more branch circuit, single grounded
receptacle. The receptacle should be located inside the cabinet directly
above the Microwave Oven mounting location.
NOTE:
• If you have any questions about the grounding or electrical
instructions, consult a qualified electrician or serviceperson.
• Neither Viking nor the dealer can accept any liability for damage
to the oven or personal injury resulting from failure to observe the
correct electrical connection procedures.
Radio or TV Interference
Should there be any interference caused by the Microwave Oven
to your radio or TV, check that the Microwave Oven is on a different
electrical circuit, relocate the radio or TV as far away from the oven as
feasible or check position and signal of receiving antenna.
E
Please Read and Follow
WARNING
8
3-Prong Plug
Grounding Pin
3-Prong Receptacle
Ground
Receptacle Box