GE RAK190V Installation Instructions Manual page 3

INSTALLATION INSTRUCTIONS
WARNING
ELECTRICAL SHOCK HAZARD — Turn off power by
unplugging the unit or by removing the fuse or switching
the appropriate circuit breaker to the OFF position before
removing the existing thermostat. Failure to do so could
result in risk of electric shock.
PACKAGE CONTENTS/TOOLS REQUIRED:
Package includes:
• Thermostat base
• Thermostat
• Screws
• Wall anchors
Tools needed:
• Hammer
• Screwdriver
• Putty
TO REMOVE EXISTING THERMOSTAT
1. Turn off power to heating and cooling system by removing the fuse or
switching off the appropriate circuit breaker.
2. Remove cover of old thermostat. This should expose the wires.
3. Remove wires from wire terminals. Note which color wires are attached
to each terminal.
4. Remove existing thermostat base from wall.
5. Refer to the following section for instructions on how to install this
thermostat.
31-5000842 Rev. 0
3