Using The Time-Lapse Recording Feature; Using The One Shot Recording Feature - Hitachi VM-C52E Manual

USING THE TIME-LAPSE RECORDING FEATURE
interval.
1. In the record/pause (stand-by) mode, press TIME
LAPSE button repeately until the length of time you
want between recordings appears in the viewfinder.
¢ The interval is changed from 0:30 (30 seconds) to
1:00 (1 minute), 2:00 (2 minutes), 5:00 (5 minutes),
MAN (manual) and again to 0:30 every time the
button is pressed.
INTERVAL 0:30
2. Press the record start/stop button.
INTERVAL 0:30 INTERVAL 0:00
STANDBY REC
¢ The clock starts counting, and when it reaches
"0:00", a recording is performed for a second,
and then the record/pause (stand-by) mode is
entered. After 30 seconds, recording is repeated
for another second.
3. Press the record start/stop button to stop recording.
TIME LAPSE Button
NOTES:
Do not continue to time-lapse record for more than
48 hours.
The interval time can be changed any time (even
during time-lapse recording) by pressing the TIME
LAPSE button.
If "MAN" is selected for the interval time, one shot
recording can be done. See below for operations.
When tapes recorded using the time-lapse and one
shot recording features are played back, pictures
may be distorted or colour may disappear with some
TVs, however, this does not indicate a fault.
USING THE ONE SHOT RECORDING FEATURE
This function is convenient to produce an animated
video.
One shot (a few frames) each is recorded every time the
record start/stop button is pressed. Shoot a doll, etc.
while moving it slightly between shots to produce an
animated video of your own.
1. In the record/pause (stand-by) mode, press TIME
LAPSE button repeatedly to select "INTERVAL
MAN".
2. Press the record start/stop button.
e One shot (a few frames) is recorded every time the
button is pressed.
3. Press the TIME LAPSE button so that INTERVAL
MAN disappears to stop recording. .
18
TIME LAPSE Button