Tape Transport System Adjustment; Ace Head Assembly Adjustment - Sony SLV-SE220 Service Manual

2-2 Tape Transport System Adjustment
When parts are replaced, perform the required
adjustments by referring to procedures for the tape
transport system. If there are any changes to the tape
path, first run a T-120 tape and make sure excessive
tape wrinkle does not occur at the tape guides.
1) If tape wrinkle is observed at the guide roller §, T,
turn the guide roller S, T until wrinkle disappears.
2) If the tape wrinkle is still observed at the tape
guide, perform the tilt adjustment of the ACE head.
(See page 5-3 of the Service Manual for Test Point
Locations.)
2-2-1 ACE Head Assembly Adjustment
2-2-1(a) ACE HEAD HEIGHT ADJUSTMENT
1) Run the alignment tape (KRV-52NE (NTSC) /52PL
(PAL)) in the playback mode.
2) Observe surface of the audio head using a dental
mirror.
3) Turn screw (C) clockwise or counterclockwise until
the gap of lower tape edge and the lower edge of
the control head is about 0.25mm.
(Refer to Fig. 2-3 and 2-4)
SCREW (A) SCREW (C)
TUT ADJUST HEIGHT ADJUST
X-POSITION _-&
ADJUSTING SLIT
SCREW (0)
SCREW (8)
AZIMUTH ADJUST X-POSITION LOCKING
Fig. 2-3 Location of ACE Head Adjustment Screw
AUDIO HEAD
VIDEO HEAD
|
0 ~0.25 mm
CONTROL HEAD
Fig. 2-4 ACE Head Height Adjustment
2-2-1(b) ACE HEAD TILT ADJUSTMENT
1) Playback a blank tape and observe the position of
the tape at the lower flange of tape guide.
2) Confirm that there is no curl or wrinkle at the
lower flange of tape guide as shown in Fig. 2-5 (B).
3) If a curl or wrinkle of the tape occurs, slightly turn
the screw (A) tilt adjust on the ACE head ass'y.
4) Reconfirm the ACE head height.
(BAD) (GOOD)
Fig. 2-5 Tape Guide Check
2-2-1(c) AUDIO AZIMUTH ADJUSTMENT
1) Load alignment tape (KRV-52NE (NTSC) /52PL
(PAL)) and playback the NTSC : 5KHz (PAL:
4KHz) signal.
2) Connect channel-1 scope probe to audio output
test point.
3) Adjust screw (B) to achieve maximum audio level.
(See Fig. 2-3)
2-2-1(d) ACE HEAD POSITION (X-POINT)
ADJUSTMENT
1) See "2. Alignment and Adjustment" for ACE Head
position (X-Point) adjustment.
09: