Initializinga Program - HP -67 Owner's Handbook Manual

150 Program Editing
Finally, load the program by pressing the keys shown below.
Press Display
0D@Ea
a8 002 32 54
o
a
o
0 007 35 22
With the program loaded into the HP-67, you can run the program.
For example, calculate the hypotenuse of a right triangle with side a of
22 meters and side b of 9 meters.
Before you can run the program, you mustinitialize it.
Initializing a Program
Initialization of a program means nothing more than setting up the
program (providing inputs, setting display mode, etc.) prior to the
actual running of it. Some programs contain initialization routines
that set up the data to run the program. In other programs, you may
have to initialize manually from the keyboard before running. In the
case of the program for calculating the hypotenuse of a triangle, to
initialize the program you must place the values for sides @ and b in
stack registers X and Y. (Notice that the order does not matter in this
case.) Thus, to initialize this program:
First, slide the Program Mode switch wrreMm [[lrun to RUN.
Press Display
22 EIED
9
The program for hypotenuse of a right triangle using the Pythagorean
Theorem is now initialized for sides of 22 and 9 meters.