Viking K-2000-DVA Technical Practice

Viking K-2000-DVA Technical Practice

Multi-input voice dialer/announcer
Hide thumbs Also See for K-2000-DVA:

Advertisement

Quick Links

TECHNICAL
TECHNICAL
T
T
E
L
E
E
L
E
Viking's K-2000-DVA is a fully programmable multi-input, multi-
number auto dialer and digital announcer, designed for emer-
gency and non-emergency message notification. The K-2000-
DVA has eight dry contact inputs, each of which can dial up to
eight 32-digit phone numbers and play a message up to 1 minute
in length specific to that input.
Messages can be recorded locally or remotely with a total mes-
sage time for all 8 inputs of eight minutes. When configured as
an alarm dialer, the K-2000-DVA has call progress detection
capability with normal and fast busy, call pickup, CPC and ring-
no-answer detection. The K-2000-DVA can also be set up as a
store caster (no dialing), for on-site promotional or assistance
announcements.
Programming can be done with a touch tone
phone or using a PC with a serial port con-
nection and free software available on the
Viking website: http://www.vikingelectron-
ics.com.
F
e
a
t
u
r
e
s
F
e
a
t
u
r
e
s
• Non-volatile memory (no batteries required)
• Stores up to eight 32-digit phone numbers (sixty-four
32-digit numbers total)
• 8 minutes of record time (1 minute per input)
• Programmable message repeat counter
• Programmable lap counter
• Eight inputs programmable normally open or normally
closed and enabled or disabled
• Programmable ring delay for remote programming and
alarm polling
• Programmable qualifier timer for each input (time
for an event to be qualified as an alarm)
• Programmable resume timer for each input (time
following reset for input to become active again)
• Call progress detection
• Programmable ringback limit for call progress
• Remote security and access codes
• Store caster mode
• Local or remote programming and recording
• RS-232 port for programming via a PC
• Compatible with the RC-2A and RC-3 remote DTMF
controllers
• Phone numbers may be programmed as pager
numbers (no voice message played)
• Programmable hookswitch flash before dialing
• Line level input for loading pre-recorded messages
into the unit
S
S
C
O
M
O
L
U
T
I
O
N
S
C
O
M
O
L
U
T
I
O
N
S
Voice Alarm Dialing or Store Caster
Announcements from up to Eight Inputs
P
r
a
c
P
r
a
c
2
1
C
2
1
C
F
O
R
T
H
E
S
T
F
O
R
T
H
E
S
T
A
p
p
l
A
p
p
l
Alarm Dialer
• Security/burglar/fire alarm notification
• System alarm or equipment malfunction notification
• Environmental warning notification
• Contacting personnel via numeric pagers
Store Caster
• Provide assistance or promotional announce-
ments in department stores, grocery stores, hard-
ware stores, gas stations, etc. "Customer assis-
tance needed in aisle 13..."
h
t
t
h
t
t
S
p
e
c
S
p
e
c
Power: 120V AC/12V DC 500 mA, UL listed adapter provided
Dimensions: 211mm x 160mm x 46mm (8.3" x 6.3" x 1.8")
Shipping Weight: 1.02 Kg (2.25 lbs)
Environmental: 0°C to 32°C (32°F to 90°F) with 5% to 95% non-
condensing humidity
Talk Battery: 12V DC
Touch Tone Dialing: 120 ms on/off, 50 ms on/off
CPC Detection Time: 320 ms minimum
Message Record Time: 8 minutes
Sampling Rate: 64 K (equivalent)
Input Detection Time: 80 ms with Qualifier Timer set to 0
Resolution Qualifier Timer: 1 second to 18 hours (see page 3)
Resolution Resume Timer: 1 second to 18 hours (see page 3)
Connections: (1) RJ11 jack for telco connection, (2) 3.5mm
jacks for 600-ohm audio output and record in, (1) 9 pin RS-232
for PC connection, (1) 12 position screw terminal block for inputs
K-2000-DVA
K-2000-DVA
Multi-Input Voice
t
i
c
e
t
i
c
e
Dialer/Announcer
September 16, 2008
E
N
T
U
R
Y
E
N
T
U
R
Y
i
c
a
t
i
o
n
s
i
c
a
t
i
o
n
s
P
h
o
n
e
.
.
.
P
h
o
n
e
.
.
.
p
:
/
/
w
w
w
.
v
i
k
i
n
g
e
l
p
:
/
/
w
w
w
.
v
i
k
i
n
g
e
l
i
f
i
c
a
t
i
o
n
s
i
f
i
c
a
t
i
o
n
s
7
1
5
.
3
8
6
.
8
8
6
1
7
1
5
.
3
8
6
.
8
8
6
1
e
c
t
r
o
n
i
c
s
.
c
o
m
e
c
t
r
o
n
i
c
s
.
c
o
m

Advertisement

Table of Contents
loading

Summary of Contents for Viking K-2000-DVA

  • Page 1 K-2000-DVA has call progress detection capability with normal and fast busy, call pickup, CPC and ring- no-answer detection. The K-2000-DVA can also be set up as a store caster (no dialing), for on-site promotional or assistance announcements.
  • Page 2 Viking warrants its products to be free from defects in the workmanship or materials, under normal use and service, for a period of one year from the date of purchase from any authorized Viking distributor or 18 months from the...
  • Page 3: Alarm Dialer

    0 specifying that incoming calls are not to be answered. Ringback Limit: This is the number of times the K-2000-DVA will allow the phone to ring when trying to reach a number on its phone number list before giving up and going on to the next number.
  • Page 4: Entering The Programming Mode

    Make sure the PROG/NORM switch is set to the NORM position and that there is a CO line or analog PABX/KSU extension in the TELCO jack. Step 2. Call into the K-2000-DVA on that line or extension. The unit will answer after the set ring delay (see Programming section G) and a single beep should be heard. Step 3.
  • Page 5: Factory Default Settings

    Example: To store 654321 as the security code: E. Selecting Function The K-2000-DVA can function as either an Alarm Dialer or a Storecaster. To select the Alarm Dialer mode enter ##1. To select the Storecaster mode enter ##2. F. Remote Access Code Enter a six-digit access code followed by #91.
  • Page 6 2000-DVA is normally configured to send a certain character string when activated, that is easily recognized by the user on the pager display. To accomplish this, the K-2000-DVA is programmed with the phone number for the pager, a series of pauses (usually 8 or 12 seconds), the character string that you want to appear on the pager display ("3333333333"...
  • Page 7 If the call is not answered before the programmed ringback limit is reached, the K- 2000-DVA will hang up and dial the next number in the list. If the called party goes off-hook, the K-2000-DVA starts playing the alarm message associated with that input.
  • Page 8 Due to the dynamic nature of the product design, the information contained in this document is subject to change without notice. Viking Electronics, and its affiliates and/or subsidiaries assume no responsibility for errors and omissions contained in this information. Revisions of this document or new editions of it may be issued to incorporate such changes.

This manual is also suitable for:

Rc-2aRc-3

Table of Contents