Panasonic SC-AK90 Operating Instructions Manual page 11

• ..... •.•.. .... ......°,.••.. ..... ••......
With preset stations
With non-preset stations
Received frequency
E] Press TUNER BAND to select "FM" or "AM".
The power will come on automatically.
Every time you press the button; "FM" <---.*
"AM".
[] Press TUNE MODE to select "PRESET" or
"MANUAL".
Every timeyou pressthebutton; "MANUAL",-----> "PRESET".
PRESET: For preset stations
MANUAL: For non-preset stations
_ Press v, or ^ to select the desired broadcast.
"STEREO
lights
when an FM stereo broadcast isbeing _e-
ceived. "TUNED" lights when you precisely tune in a broadcast
station.
[] Adjust the volume level.
For tuning by remote control
Specify the channel you want with the numeric keys (see page 36). m
TO designate channels 1-9
Fress theappropriate ( 1-9) preset-toning button.
To designate channels 10-12
i
(Example: Channel 12)
->10
-.I -,2
(within 10 sec.) (within 10 sec.)
[ Autohining ] i
Auto tuning is an easy way to tune in non-preset stations ( select
"MANUAL" instep2).
Hold down either v or ^, and release the button
when the frequency starts scrolling.
The radio frequency will stopautomatically on thefirst station it
picks u p.
eWhen there is outside interference, the radio may stop on a non-
broadcast frequency.
Hold down either v or ^ toresumeauto
tuning.
To stop auto tuning
Presseither v or ^ again.
If noise is excessive in the FM stereo mode []
I
Press FM MODE/BP.
("MONO" willlight u p.)
Sound will be produced in monaural, but this also reduces noise.
Press the button again to cancel. "MONCY' will go out.
• ' " " ' is
Normally, you IIwant to listen m stereo, so leave MONO' off. Th
way, you can listen to stereo broadcasts in stereo, and monaural
broadcasts in mono.
Sound is momentarily interrupted if you load/unload tapes while
listening to an AM broadcast.