Panasonic SC-AK90 Operating Instructions Manual page 10

|
i
..... .......... ..,...... ......... t. ......
Preset channel
SUp to12stations caneachbe set intheFM and AM bands automat-
ically.
elfbroadcast frequencies are pz_set inthememory, you can easily
tune inany ofthese frequencies from thesystem orremote control
unit.
eYou can also preset just those stations y ou like.
(See "Presetting onlyyour favorite stations" below.)
Press TUNER BAND to select "FM" or "AM".
The power will come on automatically.
Every timeyou pressthebutton; "FM" _ "AM".
Press TUNE MODE to select "MANUAL".
Every time you press the button; "MANUAL"<--._. "PRESET".
[] Press v or ^ until the display shows the fre-
quency from which you want to begin auto-
matic memory presetting.
[]
Tips on tuning in radio stations
(_) Hold down either v or ^ until the frequency numbers start
sc_oRing.
_) When nearingthe d_
frequency, pressthe button to
stop the scrolling and then fine ttme the broadcast.
Press and hold down MEMORY/SET until the
frequency begins to change.
This willstart presetting a utomatically. When finished, t he
radiowill tuneinlast s tation m emorized.
If auto presetting is not possible because radio signals are weak
or for some other reason, do the following.
[ Presetting only your favorite stations ]
Preset the stations one at a time.
1.. Perform above stel_ 1 and 2. Then, select a station with v and ^,
and press MEMORY/SET. "PRGM" will flash on the display.
2. While "PRGM" is flashing, select a preset chmlnel with v or ^,
and press MEMORY/SET again. "PRGM" will go out and the
station will be stored in memory.
FM allocation setting ]
The FM f_quency step is set to 0.2 MHz at the time of shipment.
By adjusting the allocation as shown below, you can enable the
system toreceive F M broadcasts allocated i n0.1 MHz steps.
1.Pressand holdTUNER BAND forapproximately 5 seconds.
The f_quency display will be returned to the minimum frequency
of the FM band and the display will begin to flash.
Keep holding for approximately 5 more seconds.
2. When the display stops flashing and indicates a diffe_nt fre-
quency number (the frequency step is changed to 0.1 MHz.), re-
lease TUNER BAND.
To return to the original frequency, repeat steps 1 to 2 above.
Afterchanging the "allocation" setting, the frequencies you pre-
viously preset inthememory will be cleared.
Memory retention
Your p_set frequencies are _tained in memory for about 2 weeks
while the system is unplugged.