Table of Contents
Advertisement
Installation
Remote
Control
Battery
Installation
Batteries: Use two "AA: batteries.
1.
Remove the battery compartment cover on back of the remote.
2.
InstaiI the batteries in the battery compartment. (Polarity (+) or () must be correct.)
3.
Reattacb the battery cover.
Battery
Replacement
For frequent remote users, replace old
batteries
with
alkaline
batteries
for
longer life.
Precaution
on Battery
Use
Incorrect installation can cause battery leakage and corrosion that witl damage the remote control
Observe the Following
Precautions:
!.
Batteries must be replaced as a pair.
2.
Do not combine a used battery with a new one.
3.
Do not mix battery types (Example: "Zinc Carbon" with Alkaline").
4.
Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5.
Battery replacement
is necessary when remote control reacts sporadically
or stops operating the
television.
J
Cable / Antenna
For proper reception, either a cable or antenna connection is required.
Cable Connection
Connect the cable supplied by your local cable company.
Note:
A cable converter
box may be required
for proper
reception.
Check with your local
Cable company
for compatibility
requirements,
Antenna
Connection
For proper reception of VHF/UHF channels, an external antenna is required. For best
reception an outdoor antenna is recommended.
°
Antenna must be selected as the signal source in the SET-UP menu.
Incoming
cable from
cable company
75 OHm4VfIF/UHF
QN BACK OF TV
Inco_lng
cable from
home antenna
!Cable
(CATV) mode is preset at [he
I factory.
Antenna users must change to
I antenna mode in the Set -Up menu.
-5-
Advertisement
Table of Contents
