Compression damping setting:
Minimum (soft):
18 click(s) in direction (b)
Standard:
9 click(s) in direction (b)
Maximum (hard):
0 click(s) in direction (b)
TIP
When turning the damping force
adjusting screw in direction (a), the
0 click position and the 1 click po-
sition may be the same.
When turning the damping force
adjusting screw in direction (b), it
may click beyond the stated spec-
ifications, however such adjust-
ments are ineffective and may
damage the suspension.
WARNING
This shock absorber assembly con-
tains highly pressurized nitrogen
gas. Read and understand the fol-
lowing information before handling
the shock absorber assembly.
Do not tamper with or attempt
to open the cylinder assembly.
Do not subject the shock ab-
sorber assembly to an open
flame or other high heat source.
This may cause the unit to ex-
plode due to excessive gas
pressure.
Do not deform or damage the
cylinder in any way. Cylinder
damage will result in poor
damping performance.
Do not dispose of a damaged or
worn-out shock absorber as-
sembly yourself. Take the shock
absorber assembly to a Yamaha
dealer for any service.
EWA10222
Instrument and control functions
Sidestand
1. Sidestand
The sidestand is located on the left
side of the frame. Raise the sidestand
or lower it with your foot while holding
the vehicle upright.
The vehicle must not be ridden with
the sidestand down, or if the side-
stand cannot be properly moved up
(or does not stay up), otherwise the
sidestand could contact the ground
and distract the operator, resulting
in a possible loss of control.
4-11
WARNING
EAU37491
4
EWA14191