Using The Clock Radio For The First Time - Sangean RCR-22 Manual

Using the clock radio for the first time

1. Place your clock radio on a flat surface.
2. Fully extend the wire aerial located on the rear of your clock radio. Place the wire antenna so that it
is straight as possible extending either above or below the radio.
3. Insert the adaptor plug into the AC socket located on the rear of your clock radio. The display will
show "time zone" for a few seconds and then the display will ask you to set your time zone. To set
the time zone, press the Tuning up/down button and the Select button to confirm. Your clock radio
will show _ _: _ _ on the display and the indicator will flash. The radio will scan for signal and if a
signal is found and received completely it will then show
the radio will show the current time.
4. If no signals are found,
radio to a position giving better reception.
IMPORTANT:
The mains adaptor is used as the means of connecting the clock radio to the mains supply. The
mains socket used for the clock radio must remain accessible during normal use. In order to
disconnect the radio from the mains completely, the mains adaptor should be removed from the
mains socket outlet completely. Characters appearing on the LCD display indicates the clock radio is
connected to and powered from the mains supply.
Clock
Manual clock setting (only if automatic setting fails)
1. Press and hold the Time button to enter the clock setting, and the hour digits will flash on the display.
2. Press the Tuning up or down button to adjust the hours. Then press the Band/Select button to confirm
the setting. The minute digits will flash on the display.
3. Press the Tuning up or down button to adjust the minutes. Then press the Band/Select button to
confirm the setting. Now the clock setting is completed.
Manual date setting (only if automatic setting fails)
1. Press and hold the Date button to enter the date setting and then the year digits will flash.
2. Press the Tuning up or down button to adjust the year. Then press the Band/Select button to confirm
the setting. The month digits will flash.
3. Press the Tuning up or down to adjust he month. Then press the Band/Select button to confirm the
setting. The date digits will flash.
4. Press the Tuning up or down button to adjust the date. Then press the Band/Select button to confirm
the setting. Now the time setting is completed.
Change 12/24 hour clock format
1. Press the Menu button to enter the setting.
2. Press the Tuning up or down button until 'CLOCK 24H' is highlighted on the display. Press the Band/
Select button to enter the setting.
3. Press the Tuning up or down button to choose 12/24 hour clock format. Press Band/Select button
to confirm the setting.
4
will be flashing on the display. It may be necessary to relocate your clock
on the screen without flashing. Now