When The Alarm Sounds - Sangean RCR-22 Manual

4. Press the Tuning up/down to choose the required alarm type, and
then press the Display/ Time set button to confirm the setting.
The alarm can be set to buzzer, FM or AM. When radio mode is
selected, the radio frequency on the display will begin to flash.
Press the Tuning up/down to adjust the required radio frequency
or the required preset number for the radio alarm, then press the
Display/Time set button to confirm the setting.
5. Press the Tuning up/down to select the required alarm volume
and press the Display/ Time set button to confirm the setting.
The alarm has now been set. Symbol for active alarm (such as
or
Note:
After the alarm is set, the alarm status will return to the clock time
after 10 seconds.

When the alarm sounds

When the buzzer alarm activates, the alarm will start softly and
gradually increase in level. It will sound for 1 minute and silence for
1 minute in repetition for 60 minutes unless cancelled. When the
other alarm types are set, the radio will sound non-stop at the se-
lected time for up to 60 minutes.
When the radio alarm is activated, the alarm will go off in Humane
Waking System. It will increase its volume in 0.5increments from 0
to your set volume.
To deactivate a sounding alarm, press the Power on/ off button to
cancel a sounding alarm.
Disabling / cancelling alarm setting
To cancel the alarm setting, press and hold the corresponding
alarm button before the alarms sound off.
) is shown on the display.
GB
9