Standard Operation - Viking BLK-3-EWP Technical Practice

b. Ademco High Speed Format
This DTMF format consists of a four digit account code, eight zone codes and one alarm type digit. With this
format you can identify up to eight different phones by using a zone per phone. A "5" in a zone position means
no alarm. The following example shows an alarm from the third phone.
Enter Ademco High Speed ID Settings Here:
c. 4+1 Express Format
This DTMF format consists of a four digit account code, two digit message type, and a single digit event code.
d. 4+2 Express Format
This DTMF format consists of a four digit account code, two digit message type, and a two digit event code.
O p e r a t i o n
O p e r a t i o n
A. Standard Operation
1. "HELP" / "CALL" Button
When the "HELP" / "CALL" button is pressed, the 1600A series phone goes off-hook and dials a pre-programmed
telephone number. The Call Connected LED momentarily flashes during tone or pulse dialing. In the event that the
line is busy or there is a ring-no-answer, the unit can be programmed to call additional phone numbers. The phone
then cycles through up to 5 pre-programmed emergency numbers until the call is answered. When the call is
answered, handsfree communication to emergency personnel is established. The digital voice announcer will auto-
matically play to identify the location of the emergency call. The
number (if programmed) and light the "Call Connected" LED. Alternatively, the phone can be programmed to auto-
matically light the "Call Connected" LED after the announcement has played a programmed number of times. The
distant party will know the location of the emergency call by either the voice announcement or by decoding the
Touch Tone I.D. number. Pressing the
the key has been pressed, the # key can be used to force the phone to hang-up.
✱
2. "INFO" Button (E-1600-20A and E-1600-52A Only)
When the "INFO" button is pressed (E-1600-20A and E-1600-52A only), the phone goes off-hook and dials the first
"INFO" phone number programmed. If a busy signal is detected or the call goes unanswered, the phone will cycle
through all three "INFO" phone numbers until the call is answered. When answered, handsfree communication is
established. Note: The voice announcement is for Emergency/Help calls only and will not play on a call initiated
from the "INFO" button.
XXXX 55 1 55555 7 #20
Account Code
Idle Zone
Account Code
Message Type
Enter 4+1 Express ID Settings Here:
XXXX 27 XX #20
Account Code
Message Type
Enter 4+2 Express ID Settings Here:
✱ key again will send the I.D. number and play the message again. Once
XXXX 17 X #20
Memory Location
Event Code
Memory Location
Event Code
key will stop the announcement, send the I.D.
✱
Memory Location
Normal Alarm
New Event
55 1 55555 7 #20
17 #20
27 #20
11.