Using Audioa/Ideo Dubbing - Hitachi VM-D975LA Instruction Manual

Using Audio/Video Dubbing
Use audio/video dubbing to record audio and video from the camcorder's built-in microphone and
camcorder onto a previously recorded tape in the camcorder.
"t Hold down the small button on the CAM/
OFF / VIDEO switch while sliding the switch to
VIDEO.
2 Insert a previously recorded tape in the cam¬
corder,
^ Use the wireless remote control and press the
^ PLAY button. Use the PLAY, F.FWD, and REW
buttons to find the place where you want to stop
dubbing.
A
Display the linear time counter with memory
("Using Memory," p44). Press the COUNTER
RESET button to set the linear time counter to
"0:00:00M".
g Use the REW and PLAY buttons to find where
you. wish to start dubbing.
g Place the CAM/OFF/VIDEO switch to CAM
position. The record pause indicator
appears and the camcorder is ready to record.
rj
Press and hold the A/V DUB buttorv then press
PLAY. This places the camcorder A/V DUB
pause mode, disappears replaced by
"A/VDUB
II".
Q Press tlie Start/Stop button on the camcorder or
^ START/STOP (PAUSE) on the remote control.
The audio/video dubbing starts. When the lin¬
ear time counter reaches "0:00:OOM" the cam¬
corder stops automatically, recording only the
portion of the tape that you selected.
Note; !f the camcorder is in AV DUB pause or
STILL mode for more than 5 minutes, the cam¬
corder stops automatically to protect the tape.
Note: When the audio/video dubbed portion Is
piayed back, noise may appear at the end of
the dubbed portion.
Eb3
VM-DS75LA/VM-D875LA/V1V1-D873LA