Table of Contents
Advertisement
Before calling a service technician, please check the following table for a possible cause of the problem and
some solutions.
Problem
TV will not turn on
No picture, no sound
No sound, picture OK
Poor sound, picture OK
Poor picture, sound OK
Poor reception
of broadcast
channels
Cannot receive above channel 13
Black box appears on the screen
Unable to select a certain channel
Solution
• Make sure the power cord is plugged in, then press POWER.
• The remote control batteries may be dead. Replace the batteries.
• Check the antenna/cable connections.
• The sound may be muted. Press VOLUME.
• The station may have broadcast difficulties. +Fryanother channel.
• Check that the SPEAKERS function in the AUDIO menu is set correctly.
• The station may have broadcast difficulties. +Fryanother channel.
• Check the antenna connections.
• The station may have broadcast difficulties. +Fryanother channel.
• Adjust the PICTURE
menu.
• The station may have broadcast difficulties. +Fryanother channel.
• Check the antenna connections.
• If you are using a VCR, make sure the TV/VCR button is set correctly.
• Make sure the TV/CABLE switch is set to the mode that corresponds
with the signal source (antenna or cable).
• The closed caption feature may be set to one of the Text modes (T 1, T2,
T3, or T4). Turn closed captioning off.
• The channel may be locked out with the CH LOCK feature, or erased
with the ADD/ERASE
feature.
Multiple images
• The station may have broadcast difficulties. +Fryanother channel.
• Antenna reception may be poor. Use a highly directional outdoor
antenna.
Poor color or no color
No stereo or SAP sound from a
known MTS broadcast
• The station may have broadcast difficulties. +Fryanother channel.
• Adjust the TINT and/or COLOR in the PICTURE menu.
• If you change the direction of the TV while the TV is activated, the
picture may suffer from color shading. If so, turn offthe TV and allow it
to cool for about 30 minutes, then turn on the TV again.
The picture should improve.
• Make sure the MTS feature is set properly.
The remote control does not operate
Cannot access signal input sources
(Video 1, Video2, Video3, or
ColorStream) or Channels 3 and 4
• Make sure the appropriate device mode is selected.
• There may be an obstruction between the remote control and the remote
control sensor. Remove the obstruction.
• The remote control batteries may be dead. Replace the batteries.
• Check
the Video Lock feature.
32/36AFX61
(E_
49
Advertisement
Table of Contents
