Jenn-Air JFX2897DRM Service Manual page 53

Accessing Freezer Compartment Components(Continued)
FC Evaporator and Component Access
1. Complete Upper Basket, Middle Basket and Lower basket
instructions steps 1-10.
2. Remove the thermistor cover by releasing the two tabs on
the right side. The freezer thermistor connector can be
accessed behind the FC evaporator cover.
A
A. Thermistor cover
B. Fan cover
3. Release the two tabs and then the center tab on the fan
cover.
A. Tabs
B. Fan cover
4. Remove the four, 1/4" (6.4 mm) screws to remove FC
evaporator cover to access FC evaporator and evaporator
components.
A
A. Freezer thermistor connector
B. Freezer fan assembly
C. Freezer Bimetal
B
A
B
B
C
5. Remove two screws to remove the fan assembly. When
installing fan make sure foam gaskets are in place.
A. Screws
B. Foam gaskets
6. Remove noise mastic tape to access bimetal before installing.
Unclip the bimetal from the suction line.
B
Door Switch
1. To remove the door switch from the cabinet wall, protect the
liner while using a putty knife to pry it out. Disconnect
harness connectors.
Four Door Bottom Mount
COMPONENT ACCESS
B
A
A
A. Mastic
B. Bimetal
n
4-21