Jenn-Air JFX2897DRM Service Manual page 38

COMPONENT ACCESS
Accessing Refrigerator Compartment Components (Continued)
Water Reservoir Cover
7. Using a 1/4" (6.4 mm) nut driver remove the two screws from
under the water filter door.
A. Two screws
8. Starting from the ice box side, place a flat head screwdriver
between the water reservoir cover and refrigerator
compartment liner creating enough room to place your hand
between the two.
9. Start from left to right, slide your hand between the water
reservoir cover and refrigerator compartment liner to
disengage the snaps.
A. Snaps (not shown)
10. Disengage rear left snap.
n
4-6 Four Door Bottom Mount
A
A
A
A. Snap
11. Slide water reservoir cover forward and disconnect LED
lighting connector to remove water reservoir cover.
A. LED connector
LED Light Modules
12. Lift out the LED light modules from water reservoir cover to
remove LED light modules.
NOTE: To remove LED modules from bottom of ice box
assembly and cabinet walls, protect the liner while using a
putty knife to pry them out.
A