Page 1
Cuda Vac Operator’s Manual MODELS Cuda Vac 55 8.704-104.0 Cuda Vac 110 8.704-105.0 Cuda Vac 110 Cuda Vac 55 8.704-105.0 8.704-104.0 For the Cuda Dealer nearest you, consult our web page at www.CudaUSA.com 9.801-714.0 - Rev A 07/18/23...
This manual should be considered a permanent AVERTISSEMENT: Les chutes et les trébuchements part of the machine and should remain with it if machine is resold. causés par des surfaces humides pourraient causer des blessures graves. CUDA VAC Operator’s Manual 9.801-714.0 - Rev A...
Then connect the other end to a close to the Cuda Vac, within 10 to 15’ (3 to 4.6m) is clean, dry source of compressed air. best. Air Line Accessory Requirements •...
3. Turn the manual air valve to the “on” position to begin emptying the Cuda Vac. 4. When you have emptied your Cuda Vac, turn the 3. Turn the manual air valve to the “on” position to manual air valve to the “off” position.
Unthreaded Ring Ends Must Not Touch NOTE: On the Cuda Vac 110 install the locking ring 3. The ends of the locking ring must not touch. Lock with the lugs downward. the locking ring in place by tightening the nut Locking Ring against the unthreaded lug.
Once the muffler assembly is removed, use a pin- Snap ring Troubleshooting The table lists common operating problems and possible solutions. If your Cuda Vac exhibits problems not listed, or if the suggested solution does not solve the issue, contact your distributor or a customer service representative. PROBLEM...
Need help?
Do you have a question about the Vac 55 and is the answer not in the manual?
Questions and answers