Table of Contents
Advertisement
Adjusting the Projected Image
1
Display the list of menus. Press any one of the four MENU
buttons on the Projector Control Panel or the MENU ON/OFF
button on the Remote Control Unit. The names of the four
menus (SETUP, INPUT, IMAGE, OPTION) will display. (See
pages 8-10.)
2
Select the menu.To select one of the four menus, press the
left or right MENU buttons on the Projector Control Panel or
the DISK PAD on the Remote Control Unit. The name of the
selected menu is highlighted in green.
3
Select the menu option.To select a menu option you want
to adjust, use the MENU buttons on the Projector Control
Panel or use the DISK PAD on the Remote Control Unit. The
selected adjustment option is highlighted in green.
Returning to Factory Default Settings
To return all the controls in a given menu to factory settings:
E
N
1
Select the menu (follow step 2 above).
G
2
Press the RESET button (on the projector control panel or
L
Remote Control Unit), and select DEFAULT.
I
S
If you change your mind, select CANCEL.
H
NOTE: To return a single control (Volume, Brightness, etc.) to
the factory setting, select only that menu option, and press
RESET. If you change your mind, select CANCEL.
Memory Function
Whenever you power OFF the projector, all picture
adjustments made for each input device (VIDEO, RGB1, and
RGB2) will be saved separately.
Freeze Function
This function displays a still picture, freezing a moving video
image (similar to the "pause" function of a VCR).
1
Press the FREEZE button on the Remote Control Unit.
2
To release the Freeze function, press the FREEZE button
again.
Magnify Function
This function allows you to magnify a portion of the
projected picture.
1
To activate the Magnify function: Press the MAGNIFY button
on the Remote Control Unit. The center of the projected
picture will double in size.
2
To change magnification: Press the [+] button to increase
magnification (maximum, 4 times). Press the [-] button to
decrease magnification (minimum, about 1.1 times)
3
To shift the magnified display area: Press the POSITION ON
button, then press the DISK PAD up, down, left, or right.
The magnified display area shifts accordingly.
4
To return to a normal display: Press the OFF button (below
the FREEZE button).
NOTE: The Magnify function is released when an INPUT
SELECT button (on projector or Remote Control Unit) or
when the timing mode (resolution or refresh rate) of a
personal computer is changed while an image is displayed.
Operation
8
E2a-PJ860.p65
8
NOTE: FREEZE and MAGNIFY can
not be used simultaneously.
ViewSonic PJ860
01-May-01, 21:22
Advertisement
Table of Contents
