Table of Contents
Advertisement
7.3
Specifying or editing functions (buttons)
The settings are made via the display configuration of the Web-based user
interface of the System Access Point.
In the display configuration of the web-based view of the System Access Point the buttons of
the device can be freely equipped. All displays installed in the system can be selected.
Only displays are listed that have been previously positioned on the floor plan!
The allocated actuator channels can be positioned on the display via drag-and-drop from the list
view. After the confirmation the configuration is taken over and becomes visible on the device
after a few seconds.
7.3.1
Creating functions
To gain access to the display configuration, first you need to change to the menu provided.
Proceed as follows from the start page:
Access via the building plan
1. Tap on the switch icon on the start (menu devices, scenes and groups) at the left edge of
the screen.
–
The "Floor plan" opens.
2. Tap on the display in the building plan whose information you want to edit.
–
A new window with the information about the selected display opens.
3. Under menu item "Display configuration" tap on the "Configure" button.
–
The "Display configuration" opens.
You can then perform the configuration of the display in the display configuration. You can add
devices or functions either via the room view or the type view.
In the room view (at the top right in the display configuration under "Rooms") select the
■
devices/functions according to their positioning in the building plan.
In the type view (at the top right in the display configuration under "Type") select the
■
devices/functions according to their type. The devices/functions are grouped here according
to type (e.g. lights, scenes, actions, etc.).
Product manual 2CKA001473B5475
Commissioning via Busch-free@home®
│39
Advertisement
Table of Contents
