Busch-Jaeger Busch-free home flex Product Manual page 37

Under "Other settings" you can configure the settings described in the following.
Pos.
[1]
[2]
[3]
Product manual 2CKA001473B5475
Commissioning via Busch-free@home®
Description
Parameters
Adjusting the brightness to
the ambient lighting
LED switch-on brightness
night [%]
LED switch-on brightness
day [%]
Switchover of display via the
proximity sensor
Proximity sensor sensitivity
Haptic feedback
Simple view
Activating automatic return to
the start page [s]
Screensaver mode
Screensaver
Display of idle state
Installed in solid wall
Authorizations
Menu item "Authorizations" is used to specify whether a user with installer authorization
is required for the reconfiguration of the device.
In addition, you can nevertheless assign users with read rights the authorization to
switch this device.
Information about the device
Listing of device information (device number, software version, etc.)
By activating or deactivating the parameter, the
automatic adjustment of the display brightness to
the ambient brightness is activated.
Setting the LED switch-on brightness for night in %
via the -/+ buttons.
Notice: The parameter only functions when a time
profile with the application "LED day/night
switchover" is available. The device (channel) must
be linked with this application!
Setting the LED switch-on brightness for day in %
via the -/+ buttons.
Notice: The parameter only functions when a time
profile with the application "LED day/night
switchover" is available. The device (channel) must
be linked with this application!
Specifying whether the proximity sensor is to be
used for switching the display.
The parameter us used to specify the sensitivity of
proximity sensor.
The parameter is used to specify whether a haptic
feedback is to take place.
This parameter is used to deactivate or activate the
simple view.
In this view the information is illustrated in reduced
form.
The extended view offers additional setting options
and information.
This parameter is used to set the the number of
seconds after which the display view changes
automatically to the start page.
Specifying the form in which the screen saver is to
be displayed.
Specifying the time at which the screen saver is to
be activated.
The parameter is used to specify when the display
is to switch over into the idle state.
The parameter can be used to specify whether the
display was installed in a solid wall. If this is the
case, the parameter should be set on "Yes".
│37