Additional Water Treatment Chemicals - Kamco CF40 Operating And Servicing Manual

ADDITIONAL WATER TREATMENT CHEMICALS

The following chemicals have specialist applications for cleansing or protection.
Issue: May 2023
SYSTEM PRE-CLEAN Pre-commissioning cleaner.
Essential treatment for new and modified heating systems, to eliminate and neutralise
installation debris, corrosive flux residues, oil and grease.
Add to the system and operate the system for at least one hour, with all the radiator
valves open. Heat will improve the efficiency.
Drain the system thoroughly prior to refilling, adding Kamco SystemSafe-DM inhibitor for
long term protection.
Application: 500ml per 100 litre heating system capacity (typical 10 radiators).
SYSTEMHUSH The solution for 'kettling' and boiler noises.
Added to the system water to stop boiler noises and 'kettling'. SystemHush removes
baked on corrosion and light scale from boilers and heat exchangers during normal
operation, and may be left in the system.
System-Hush commences working immediately, but may take 2-3 weeks for full effect. It
may be left in the system with the addition of Systemsafe-DM inhibitor.
Application: 500ml per 100 litre heating system capacity (typical 10 radiators).
SYSTEMSEAL Leak sealer for heating systems.
A simple and economical solution for curing minor leaks in heating systems.
SystemSeal finds and penetrates leaks. The presence of air causes the polymer to set into
a flexible seal, preventing further loss of water. Most leaks will be cured within 24 hours.
It may be left in the system but must be used in association with SystemSafe-DM
inhibitor to prevent further scaling or corrosion.
Application: 500ml per 100 litre heating system capacity (typical 10/12 radiators).
FREEZBREAKER-LT Non-toxic antifreeze for heating systems.
Antifreeze additive to protect heating and cooling systems down to –32°C.
Compatible with all Kamco water treatment products, and suitable for all materials
commonly used in heating systems, including aluminium.
Use in association with SystemSafe-DM inhibitor.
25% solution provides protection down to –12°C.
33% solution provides protection down to –17°C.
50% solution provides protection down to –32°C.
SYSTEMSAFE-BIO Biocide and fungicide for heating systems
A stabilised blend containing a broad-spectrum biocide for the removal and elimination
of bacteria and fungal matter in hot water and chilled water systems.
Ideal for cleaning and treating under-floor and low temperature heating systems which
are prone to bacterial contamination.
Application: 250ml per 100 litre heating system capacity (typical 10/12 radiators).
Section F – Power Flushing Accessories
Page F.17