Kubota WSM 05-E3B Series Workshop Manual page 78

05-E3B, 05-E3BG, WSM
CAUTION
• Check the nozzle injection pressure and condition after confirming that there is nobody standing in the
direction the fume goes. If the fume from the nozzle directly contacts the human body, cells may be
destroyed and blood poisoning may be caused.
Nozzle Spraying Condition
1. Set the injection nozzle to a nozzle tester, and check the nozzle
spraying condition.
2. If the spraying condition is defective, replace the nozzle piece.
(a) Good
Fuel Injection Pressure
1. Set the injection nozzle to a nozzle tester.
2. Slowly move the tester handle to measure the pressure at which
fuel begins jetting out from the nozzle.
3. If the measurement is not within the factory specifications,
replace the adjusting washer (1) in the nozzle holder to adjust it.
(Reference)
• Pressure variation with 0.01 mm (0.0004 in.) difference of
adjusting washer thickness.
Approx. 235 kPa (2.4 kgf/cm
Fuel injection pressure Factory spec.
(1) Adjusting Washer
Valve Seat Tightness
1. Set the injection nozzle to a nozzle tester.
2. Raise the fuel pressure, and keep at 12.75 MPa (130.0 kgf/cm
1849 psi) for 10 seconds.
3. If any fuel leak is found, replace the nozzle piece.
Valve seat tightness Factory spec.
S-23
DIESEL ENGINE
(b) Bad
2
, 34 psi)
13.73 to 14.70 MPa
140.0 to 150.0 kgf/cm
1992 to 2133 psi
No fuel leak at
12.75 MPa
2
130.0 kgf/cm
1849 psi
KiSC issued 12, 2007 A
W10181310
2
W10182100
2
,
W10183690