Check Points Of Initial 50 Hours - Kubota WSM 05-E3B Series Workshop Manual

05-E3B, 05-E3BG, WSM

[2] CHECK POINTS OF INITIAL 50 HOURS

Changing Engine Oil
CAUTION
• Be sure to stop engine before changing engine oil.
1. Start and warm up the engine for approx. 5 minutes.
2. Place an oil pan underneath the engine.
3. To drain the used oil, remove the drain plug (1) at the bottom of
the engine and drain the oil completely.
4. Screw the drain plug (1).
5. Fill new oil up to upper line on the dipstick.
IMPORTANT
• When using an oil of different maker or viscosity from the
previous one, remove all of the old oil.
• Never mix two different types of oil.
• Engine oil should have properties of API classification. (See
page G-6.)
• Use the proper SAE Engine Oil according to ambient
temperature.
• Upon an oil change, be sure to replace the gasket with new
one.
Above 25 °C (77 °F)
0 °C to 25 °C (32 °F to 77 °F)
Below 0 °C (32 °F)
Oil pan depth
Extended Type
110 mm
(4.33 in.)
Models
D1005-E3B / E3BG
D1105-E3B / E3BG
D1105-T-E3B
D1305-E3B / E3BG
1.5 U.S.gals
V1505-E3B / E3BG
V1505-T-E3B
Drain plug with
copper gasket
Tightening
torque
Drain plug with
rubber coated
gasket
(1) Drain Plug
G-9
SAE 30 or SAE 10W-30
SAE 10W-40
SAE 20 or SAE 10W-30
SAE 10W-40
SAE 10W or SAE 10W-30
SAE 10W-40
Capacity
Standard Type
125 mm
(4.92 in.)
5.1 L
–
1.3 U.S.gals
5.7 L
–
– –
33 to 37 N·m
M12 × 1.25
3.3 to 3.8 kgf·m
24 to 27 lbf·ft
45 to 53 N·m
M22 × 1.5
4.5 to 5.5 kgf·m
33 to 39 lbf·ft
KiSC issued 12, 2007 A
G GENERAL
130 mm
(5.12 in.)
–
–
6.7 L
1.8 U.S.gals
W1016604