Table of Contents
Advertisement
PRECAUTIONS
SAFETY
Before connecting the instrument to the power source, care-
fully read the following information, then verify that the
power cord and power line fuse are ones for your power line.
The instrument's rear panel has a fuse holder on the left of
the AC inlet terminal! (the fuse holer also serves as a vol-
tage selector). The value under the triangle WV marked on
the holder indicates the line voltage set for the instrument.
If the power cord is not applied with the correct voltage,
there is a danger from electric shock.
©
When converting the voltage, refer to the Maintenance
section.
Line voltage
This instrument operates using ac-power input voltages that
100/120/220/240 V at frequencies from 50 Hz to 60 Hz.
Power cord
Line fuse
10.
. Always connect a cable from the earth ground (GND)
Advertisement
Table of Contents
