Table of Contents
Advertisement
AV2:
AT:
1/AT:
RATIO.
a minus value is displayed.
Setting
of the
HORIZ
MODE
select
switch @ to the X-Y position disables
AV2 mode measurement.
@) is displayed posterior to AT.
RATIO.
cursor, a minus value is displayed.
NOTE: Setting
of the
HORIZ
MODE
select
switch @ to the X-Y position disables AT
mode measurement.
quency is displayed in an absolute value.
NOTE: Setting
of the
HORIZ
MODE
select
switch @ to the X-Y position disables
1/AT mode measurement.
@®
A Control (CS-5130 only)
Controlter for shifting the measuring cursor (rough dot-
ted line) out of two cursor lines displayed on the CRT
in the cursor measurement. By rotating the controller
clockwise, the cursor line moves upward or rightward:
by rotating counterclockwise, it moves downward or
leftward.
A REF/DELAY TIME POSITION Control
(DELAY TIME POSITION only on the CS-5135)
Controller for shifting the reference cursor (small-dotted
line) out of two cursor lines displayed on the CRT in the
cursor measurement. By rotating the controller clock-
wise, the cursor line moves upward or rightward: by
rotating
counterclockwise,
it moves
downward
or
leftward.
This controller is also used to set delay time of the B
sweep Start point from the A sweep start point, if the
HORIZ MODE selector is set to ALT or B position. (DE-
LAY TIME POSITION)
It controls delay time continuously betweenO.2 and 10
times of a set value with the A SWEEP TIME/DIV con-
troller.
13
Advertisement
Table of Contents
