Table of Contents
Advertisement
DIRECTIONS
1 Cursor mode
Seer
Ieee
le seo tl
ca
eae
eee
Seale alles a
Reel teal oll
FOR USE
2 Cursor measurement value
see
3 CH1 scale factor
5 ADD
6 CH2 invert
4CH2 scale factor
Fig. 6
1 Cursor Mode
The current setting cursor mode, which depends on the
combination of the operation controls, is displayed.
AV1, AV2, AT, 1/AT, RATIO, PHASE
2 Cursor Measuring Data
The result measured by the two cursors is displayed. In
the 1/4T mode, when the two cursors approach each
other and the measurement nears its limit, a '*?'" will be
displayed in front of the measured data. This shows that
the measured data is not available.
3 CH1 Scale Factor
Displays the CH1 vertical axis sensitivity to one division.
When not in CAL mode. a ''>"' is displayed posterior to
CH1.
NOTE: This is not displayed when the MODE switch a
is set to CH2.
4 CH2 Scale Factor
Displays the CH2 vertical axis sensitivity to one division.
When not in CAL mode. a''>"' is displayed posterior to
CH2.
NOTE: This is not displayed when the MODE switch @
is set to CH1.
5 ADD
"4" is displayed when the MODE switch (1) is set to
ADD.
SESSnsee
S=Scnnns
7 A sweep scale factor
8 B sweep scale factor
6 CH2 INVERT
The inverted polarity of CH2 ''!'' is displayed by con-
trolling the ¥ POSITION/PULL INV ©.
7 A Sweep Scale Factor
Displays a sweep
range selected with the
A SWEEP
TIME/DIV @).
When the SWEEP VARIABLE is not set to CAL mode, a
"">"' is displayed posterior to A.
8 B Sweep Scale Factor
Displays a sweep
range selected with th: B SWEEP
TIME/DIV if the HORIZ MODE @ is set to ALT or B.
By pulling the <® POSITION/PULL x 10 MAG @), 1/10
scale factors of the A SWEEP TIME/DIV @) aid B SWEEP
TIME/DIV @ are displayed. If the HORIZ MCD E @ is set
to X-Y position, ''X-Y"' is displayed insteadof A andB
sweep ranges.
9 Delay Time
The cursor mode and cursor measuring dataawe not dis-
played if the HORIZ MODE @ is set to ALTor B. ''DE-
LAY" is displayed in place of the cursor node, anda
delay time is displayed in place of the curso rneasuring
data.
If the triggered delay (B TRIG'D) is selected' ~?"' is dis-
played posterior to DELAY.
15
Advertisement
Table of Contents
