Hints And Tips - AEG CCE84779XB User Manual

• The heat setting display of the left
front control bar shows the heat
setting for this function. To change
the heat setting use the left front
control bar only. The left rear control
bar is deactivated while the function
operates.
In some models there are
two flexible cooking areas,
left and right. To operate
PowerSlide on the right side,
use the right front control
bar.
Use only one pot with a
minimum bottom diameter of
160 mm when you operate
the function.
1. Place the correct cookware on the
left front side of the cooking area.
2. Press and hold
hob.
A signal sounds and indicators above
and appear.
3. Press

8. HINTS AND TIPS

WARNING!
Refer to Safety chapters.
8.1 Cookware
For induction cooking zones
a strong electro-magnetic
field creates the heat in the
cookware very quickly.
Use the induction cooking zones with
suitable cookware.
• To prevent overheating and improve
the performance of the zones, the
to activate the
to activate the function.
A signal sounds and an indicator above
the symbol appears.
4. Move the cookware back and forth
on the cooking area as needed. To
change the position of the cookware
lift it up and place it on a different
part of the area. Do not slide the
cookware as it may cause scratches
and discolouration of the surface.
The heat setting level on the control bar
adjusts automatically.
5. To change the default heat setting
levels, move the cookware to the
area you want to adjust first.
6. Press any of the available heat
setting levels on the left front control
bar.
The updated heat setting levels will be
remembered for the next time you use
the function.
7. Repeat the procedure for the
remaining cooking areas, if needed.
8. To deactivate the function, press
You can also press 0 on the left front
control bar.
A signal sounds and the indicator above
the symbol disappears. The heat setting
level changes to 0.
You can set a timer while PowerSlide
operates. In this case the timer does not
deactivate the cooking zones when the
set time runs out. The timer affects all
three cooking areas activated by the
function at the same time.
cookware must be as thick and flat as
possible.
• Ensure cookware bases are clean
and dry before placing on the hob
surface.
• Always be careful no to slide or rub
the cookware on the edges and
corners of the glass as it may chip or
damage the glass surface.
Cookware material
• correct: cast iron, steel, enamelled
steel, stainless steel, multi-layer
bottom (with a correct marking from a
manufacturer).
ENGLISH 21
.