Coolant - Yamaha WR25R 2008 Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT

Coolant

The coolant level should be checked
before each ride. In addition, the cool-
ant must be changed at the intervals
1
specified in the periodic maintenance
and lubrication chart.
2
To check the coolant level
3
1. Place the vehicle on a level sur-
face and hold it in an upright posi-
4
tion.
TIP
5
G The coolant level must be checked
on a cold engine since the level
6
varies with engine temperature.
G
Make sure that the vehicle is posi-
tioned straight up when checking
7
the coolant level. A slight tilt to the
side can result in a false reading.
8
2. Check the coolant level in the cool-
ant reservoir.
9
TIP
The coolant should be between the
minimum and maximum level marks.
EAU20070
EAU20253
1. Maximum level mark
2. Minimum level mark
3. If the coolant is at or below the
minimum level mark, remove pan-
el C (See page 7-8.), remove the
reservoir cap, add coolant to the
maximum level mark, and then in-
stall the reservoir cap and the pan-
el. WARNING! Remove only the
coolant reservoir cap. Never at-
tempt to remove the radiator
cap when
hot. NOTICE: If coolant is
[EWA15161]
not available, use distilled water
or soft tap water instead. Do not
use hard water or salt water
since it is harmful to the engine.
If water has been used instead
7-15
1
2
1. Coolant reservoir cap
the engine is
Coolant reservoir capacity (up to the
maximum level mark):
of coolant, replace it with cool-
ant as soon as possible, other-
wise the cooling system will not
be protected against frost and
corrosion. If water has been
added to the coolant, have a
Yamaha dealer check the anti-
freeze content of the coolant as
soon as possible, otherwise the
effectiveness of the coolant will
be reduced.
[ECA10472]
1
0.25 L (0.26 US qt, 0.22 Imp.qt)