Crown CT25007HX Original Instructions Manual page 22

Symbol
Power tool designation
The cordless sabre saw is designed for cutting wood-
en, plastic and metal workpieces� Special saw blades
extend significantly the application range of the power
tool and allows for cutting various materials, curved
sawing, flush cutting, deep cutting, etc.
Power tool components
1 Rotary handle
2 Lock-off button
3 On / off switch
4 Rotary handle lock
5 Ventilation slots
6 Body
7 Locking lever
8 LED lamp
9 Fixing sleeve
10 Saw holder
11 Support plate
12 Battery lock *
13 Battery *
14 Control button of the state of battery charge *
15 Indicators of the state of battery charge *
16 Charger *
17 Saw blade *
18 Indicator (green) *
19 Indicator (red) *
20 Label *
* Optional extra
Not all of the accessories illustrated or described
are included as standard delivery.
Meaning
A sign certifying that the
product complies with es-
sential requirements of the
EU directives and harmo-
nized EU standards�
Useful information�
Wear protective gloves�
Stepless speed control�
Do not dispose of the power
tool in a domestic waste
container�
Installation and regulation of power tool
elements
Before carrying out any works on the power tool
remove the battery 13.
The inserting / replacing of the saw blade (see
fig. 1)
As a result of the long use the saw
blade 17 may become quite hot and
the sharp cutting edges may injure the
user, therefore one must always use
protective gloves when inserting / replacing the
saw blade 17.
• Turn the fixing sleeve 9 as shown on figure 1.1 and
keep it in this position:
• when installing the saw blade 17 - insert saw
blade 17 shank into the saw holder 10 (see fig. 1.2);
• when removing the saw blade 17 - take out the
saw blade 17 from the saw holder 10� Warning: be-
fore removing the saw blade 17 make sure it has
cooled down enough after work.
• Release the fixing sleeve 9 (see fig. 1.3).
• Check tightness of the saw blade 17 by pulling it�
Warning: if fixed insecurely, saw blade 17 can
cause injures.
• The saw blade 17 is allowed to be installed with
teeth up - this may be required for specific kinds of
work�
Support plate (see fig. 2-3)
The support plate 11 facilitates work with the pow-
er tools, it provides perpendicularity of the saw
blade 17 towards the workpiece and also serves as
sawing stop allowing adapting to sawed material posi-
tion�
• Facilitated by pivot fixing, the support plate 11 au-
tomatically slopes depending on surface slope angle
(see fig. 2).
• To move the support plate 11 forward or backward,
do the following:
• turn the locking lever 7 as shown on figure 3.1;
• set the support plate 11 into required position by
moving it forward or backward (see fig. 3.2);
• turn the locking lever 7 as shown on figure 3.3.
Charging procedure of the power tool
battery
Initial operating of the power tool
The power tool is supplied with a partially charged
battery 13. Before the first use, the battery 13 must
be fully charged.
Charging process (see fig. 4)
• Press the battery lock 12 and remove the battery 13
(see fig. 4.1).
• Connect the charger 16 to the power supply�
• Insert battery 13 into charger 16 (see fig. 4.2).
English
22