Connecting Inlet Hose - Daewoo DWD-F1012 Service Manual

Connecting inlet hose

In using only one water tap or in case of only one water inlet valve, connect the inlet hose to the cold water inlet valve.
Option : Be careful not to confuse hot water inlet and cold water inlet.
FOR ORDINARY TAP
1 Pull down the collar
of the inlet hose to
separate it from the
water tap adapter.
4 Remove the tape,
and screw connector
B into connect A
tightly.
Connector A
Connector B
FOR SCREW-SHAPED TAP
1 Conect the inlet hose
to the water tap
adapter by pulling
down the collar of the
hose end.
Rubber
Packing
Connector D
Inlet Hose Connector C
2 Loosen the four
screws properly in
order to fit into
water tap.
5 Conect the inlet hose
to the water tap
adapter by pulling
down the collar of the
hose end.
2 Conect the connector-
inlet supplied if
necessary.
Connector
Inlet
Rubber
Packing
Connector D
Hose
Connector C
3 Fit the water tap adapter into
the water tap and tighten the
four screws evenly while push-
ing up the adapter so that the
rubber packing can stick to the
water tap tightly.
6 Connect the inlet hose
adapter of the hose to the
water inlet of the washer by
turning it clockwise to be fixed
tightly.
• Please check the rubber pack-
ing present inside the inlet hose
adapter of the hose.
3 Connect the inlet hose adapter
to the water inlet of the washer
and turn it to be fixed.
• Check the packing in the inlet.
INSTALLATION
TAPE
7