Cleaning The Controls Linkage Assembly - Toro 25545T Operator's Manual

Adjusting the Neutral Position (continued)
3. Adjust the adjustment nut
which way the machine is moving:
• If the machine is moving forward, turn the
nut counter clockwise.
• If the machine is moving rearward, turn the
nut clockwise.
4. Tighten the jam nuts on each end of the rod.
5. Test the machine to see if further adjustment is
needed.

Cleaning the Controls Linkage Assembly

Spray the direction controls linkage assembly with
compressed air.
3467-222A
depending on
G416197
G416166
Page 7–18 Maintenance: Controls Maintenance