Fuse Replacement; Addressing The Hp 70206A System Graphics Display; Determining The Hp-Msib Address - HP 70205A Installation And Verification Manual

Fuse Replacement
You can locate the line fuse inside the power-cord receptacle housing on the back of the
instrument. Also included in this housing is a spare fuse. The fuse is a 5 by 20 mm fuse
rated at 6.3 A, 250 V, HP part number 2110-0703. Refer to Figure 2-5 for fuse removal and
replacement.
\ INSERT SCREWDRIVER
\ PRY OPEN
FUSE IN USE
SPARE FUSE
Figure 2-5. Fuse Removal and Replacement
Addressing the HP 70206A System Graphics Display
The HP 70206A needs an appropriate HP-MSIB address to allow communication with the
system master. Use the display's address switch to set the display's HP-MSIB and HP-IB
addresses.
Determining the HP-MSIB Address
The HP 70206A has a factory-preset HP-MSIB column address of 4. Figure 2-6 shows the
address map for an HP 70206A System Graphics Display. The addresses in this figure are
factory-preset for the display.
To access the address map:
1. Press the hardkey.
2. Press the |
Refer to HP 70205A and HP 70206A Operation Manual for more information about using the
address map.
Installation 2-7