Table of Contents
Advertisement
1. Ensure that the battery is fully charged.
2. Set the battery in the battery holder.
3. Place the battery shield on the battery bracket.
4. Install the battery hold-down strap.
5. Connect and tighten the red (positive) cable first.
6. Connect and tighten the black (negative) cable last.
Verify the battery cables and wiring harness do not come into contact with the
brake disc. Move the wiring harness/cables behind the chassis tube and away
7. Route the BROWN harness ground wires
ground cable
rubber strap. If the ground wires/cable are routed down the side of the
battery, they may interfere with the rear side panel tab. Note the routing of
the RED (positive) battery cable
from the chassis. Item
8. Verify that cables are properly routed.
Ensure that the battery wires are routed in such a way that they cannot come
from the brake disc.
w
as shown in the image. Both are routed up and over the
r
is the constant power fuse connector.
into contact with the brake disc.
CAUTION
q
and BLACK main battery
e
and that the right fender is pulled away
NOTICE
MAINTENANCE
169
Advertisement
Table of Contents
