Table of Contents
Advertisement
Perform this procedure in a well-ventilated area. Use the recommended 50/50
1. Remove right side panel.
2. Fill the coolant bottle to the COLD FILL mark.
3. Install the coolant bottle cap to the half lock position. Do not tighten to the
fully seated position.
4. Lock the parking brake.
5. Start the engine and allow it to run at a fast idle for several minutes, until the
tunnel coolers are warm to the touch.
Keep the coolant level in the coolant bottle at or near the COLD FILL mark
when engine is running. The engine may suck the coolant down quickly which
my require coolant to be added a few times to stabilize the coolant level.
6. When all tunnel cooler extrusions are warm to the touch, stop the engine.
7. Allow the engine and cooling system to cool.
8. Fill the coolant bottle to the COLD FILL mark. Reinstall the bottle cap
securely.
9. Reinstall the right side panel.
EXHAUST SYSTEM
Check the exhaust system for wear or damage at approximately 2000 miles
(3200 km). Always allow the engine and exhaust system to cool completely
before inspecting.
Hot exhaust system parts can cause burns. Allow adequate time for the
exhaust system to cool. Never perform this procedure with the engine running.
1. Open the side panels and remove the hood. See page 140.
2. Inspect the muffler and pipes for cracks or damage.
3. Check for weak or missing retaining springs or damper/support grommets.
4. Check for loose clamps on the pipe covers.
CAUTION
Extended-Life Antifreeze.
CAUTION
WARNING
MAINTENANCE
145
Advertisement
Table of Contents
