Vitek VT-1339 Manual Instruction page 12

ENGLISH
•
Do not hang or keep the unit in places where it can fall into a
bath or a sink filled with water; do not immerse the unit body,
power cord or power plug into water or other liquids.
•
Do not use the unit while taking a bath.
•
If the unit is dropped into water, unplug it immediately and
only then take it out of the water.
•
Do not use the unit if the power cord or power plug is
damaged.
•
For children safety reasons do not leave polyethylene
bags, used as a packaging, unattended.
Attention! Do not allow children to play with polyethylene
bags or packaging film. Danger of suffocation!
•
Do not allow children to touch the unit body, the power
cord or the power plug during operation of the unit.
•
Do not leave children unattended to avoid them using the
unit as a toy.
•
Close supervision is necessary when children or disabled
persons are near the operating unit.
•
This unit is not intended for usage by children.
•
The unit is not intended to be used by people with physi-
cal, sensory or mental disabilities (including children) or
by persons lacking experience or knowledge if they are
not under supervision of a person who is responsible for
their safety or if they are not instructed by this person on
the usage of the unit.
•
Do not use the unit when you are drowsy.
•
Do not use the unit to straighten wet hair or synthetic wigs.
•
Take the unit by its handle only. Do not touch the unit body
in the area of the heating plates.
•
Avoid contact of heated surfaces with your face, neck and
other parts of your body.
•
Do not put the operating unit on heat-sensitive or soft sur-
faces (for instance, bed or sofa) and do not cover the unit.
Be careful! The heating plates and the unit body in the area
of the heating plates remain hot for some time after the unit
is unplugged.
•
It is recommended to unwind the power cord to its full
length while using the unit.
•
The power cord should not:
– touch hot objects;
– run over sharp edges;
– be used as a handle for carrying the unit.
•
Check the integrity of the power cord periodically.
•
If the power cord is damaged, it should be replaced by the
manufacturer, a maintenance service or similar qualified
personnel to avoid danger.
12