Table of Contents
Related Manuals for Vent-Axia SDX EC Series
Summary of Contents for Vent-Axia SDX EC Series
- Page 1 SDX EC In-Line Centrifugal Duct Fans With EC Motors Installation and Wiring Instructions Stock Ref. N° SDX125EC SDX150EC SDX200EC SDX250EC SDX315EC 220-240V~50Hz PLEASE READ INSTRUCTIONS IN CONJUNCTION WITH THE ILLUSTRATIONS. PLEASE SAVE THESE INSTRUCTIONS...
- Page 3 C. Ensure that the mains supply (Voltage, Frequency, and Phase) complies with the rating label. D. The Fan should only be used in conjunction with the appropriate Vent-Axia products. E. It is recommended that the connection to the fan connecter terminals is made with flexible cable.
- Page 4 Attaching the mounting foot Screw foot to fan as shown Using the self drilling / Fan mounting foot tapping screws provided. (A pilot hole maybe required). WIRING. WARNING: THE FAN AND ANCILLARY CONTROL EQUIPMENT MUST BE ISOLATED FROM THE POWER SUPPLY DURING THE INSTALLATION / OR MAINTENANCE. THE SDX EC FANS ARE CLASS 1 AND MUST BE EARTHED.
- Page 5 SERVICING AND MAINTENANCE. WARNING: THE FAN AND ANCILLARY CONTROL EQUIPMENT MUST BE ISOLATED FROM THE POWER SUPPLY DURING MAINTENANCE. Maintenance should be performed only by the trained and qualified personnel. Fan bearings do not require any maintenance. If the fan is not equipped with the air filter the only requirement for the maintenance of the fan is to clean the impeller.
- Page 6 [ % ] (CAL(R) @ -400 Pa) Casing sound power level (Lwa) [ dB(A) ] ErP Compliance 2018 2018 2018 2018 2018 www.vent-axia.com Internet address for disassembly instructions Dimensions and Weight øD øD1 weight SDX EC [mm] [mm] [mm] [mm]...
- Page 8 TECHNICAL SUPPORT: Tel: 0344 8560594 Fax: 01293 539209 For details of the warranty and returns procedure please refer to www.vent-axia.com or write to Vent-Axia, Fleming Way, Crawley, RH10 9YX EU Authorised Representative: Vent-Axia Sigarenmaker 5 - 5521DJ Eersel Nederland authorisedrep@vent-axia.nl 413044A...
Need help?
Do you have a question about the SDX EC Series and is the answer not in the manual?
Questions and answers