Table of Contents
Advertisement
Door assembly instructions
The machine can be fitted with a
furniture door with either a left hand or
right hand hinge. The machine is
supplied with the hinge fastening plates
fitted on the left hand side.
To change the door hinging from the left
hand side to the right, the hinge
fastening plates need to be fitted to the
right hand side of the machine, in place
of the plastic plugs. The plastic plugs
then need to be refitted where the plates
were previously located (4 Figure 4).
To fit the door to the appliance, it is
necessary to drill two 35mm diameter
holes, 14mm deep to take the hinges.
Follow the dimensions given in Figure 5
for the positioning of the holes.
Note that the dimension A given is
measured from the top of the appliance
to the first hinge and should be adjusted
if the door is intended to be higher than
the top of the appliance.
To align the door perfectly it may be
necessary to adjust the height of the
plates (2 Figure 4). To do this, loosen the
plastic screws (3 Figure 4), realign the
door and retighten the screws.
Advertisement
Table of Contents
