Advertisement
◎ Utilizes Cree XM-L2 U2 LED with a lifespan of 50,000 hours
◎ Powered by one 16340 rechargeable Li-ion battery or one CR123A Lithium battery
can be taken under emergency circumstance
◎ 72mm Length x 21.5mm Diameter
◎ 45 grams (excluding battery and charging cable)
◎ Magnetic suction charging port in the neck, one included 16340 rechargeable Li-ion
battery
◎ Tailored magnetic charging cable also available in portable MICRO USB devices
◎ One-switch for fast and convenient operation
◎ Specialized two-position body clip, magnetic suction bottom
◎ Lock-out function avoids accidental operation
◎ Intelligent over-heat protection to avoid high temperature of the surface
◎ Low-voltage warning reminds when battery replacement is needed
◎ Reverse polarity protection, to protect from improper battery installation
◎ Digitally regulated output maintains constant brightness
◎ Made of durable aircraft-grade aluminum
◎ Premium type Ⅲ hard-anodized anti-abrasive finish
◎ Toughened ultra-clear glass lens with anti-reflective coating
Operation Instruction
ON/OFF
When the light is off and unlocked, press and hold the side switch for 0.5 seconds to turn it
on. When the light is on, press and hold the side switch for 0.5 seconds to turn it off.
Output Selection
With the light on, single-click the side switch to cycle through Low→Mid→High→Turbo.
Strobe
Under unlocked state, press and hold the side switch for 1.2 seconds to enter into Strobe,
click again to turn back to previously used General brightness level.
Lock-out Function
Lock: When the light is off and unlocked, double-click the side switch in 0.5 seconds, the
light will blink at Mid twice and then go out, indicating the light is locked.
Unlock: When the light is off and locked, double-click the side switch in 0.5 seconds, the
light will be unlocked and power on the last-used output level.
Note: In locked state, the light only responds unlocking operation, press the side switch,
the light will blink twice to remind the light is under locked state.
Intelligent Memory Circuit
The flashlight memorizes the last brightness level used in the General mode, the next time
it is turned on, it will recall that previously used General brightness level.
Advertisement
