Champion M2 Series Operation, Cleaning, And Maintenance Manual page 15

Hide thumbs Also See for M2 Series:
Table of Contents

Advertisement

BASIC OPERATION
8
a
8. Insert the dish rack into machine and close doors. 'WASHING' appears in the message bar
and machine begins to wash. A block, (a), with 'CYCLE 1 MINUTE' is displayed. The block
may be pressed to advance the time from 2, 4, or 6 minutes during the cycle.
If 'Cycle 1 Minute' is selected during a previously selected 'Cycle 2 minute' selection,
the cycle will complete a 2 minute wash cycle instead of restarting a 1 minute cycle.
9. 'RINSING' appears in the message bar at the end of the wash cycle. The rinse temperature,
(a), must be between 180-195ºF/82.2-90.5ºC to achieve proper sanitization. 'TIME
REMAINING' indicates the time left in the total cycle. Refer to Cycle Times on page 3 for
time increments.
10
10. 'DWELLING' appears in the message bar when the rinse cycle time ends. The wash
pump and final rinse spray are off during this time. Open doors and remove dish rack.
11. OPTIONAL VHR MACHINES ONLY: After the dwell cycle, VHR machines display
'RECOVERY' in the message bar for 30 seconds as a vent fan cools and exhausts air
from the wash cabinet. Open doors and remove dish rack when the door latch unlocks.
12
12. The display screen returns to the start point for the next cycle. Note the red door icon
indicates the door is open.
13. The display indicates 'SLEEP' if the machine is idle for an extended period of time. The
tank and booster heat de-energizes to conserve energy. Touch the screen to wake up.
9
a
11
FOR VHR MACHINES ONLY
13
Operation
b
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dh6000-vhrDh6000t-vhrDh6000-standardDh6000t-standard

Table of Contents