Table of Contents
Advertisement
2415—-UW ULTRASONIC CLEANER
5. Adjustments and Calibration
SETTING THE TIMER MODE
360617 Η
SCROLLING:
A: ON Delay
H: interval
b: Single Shot
C: Delay on Release
d: Repeat Cycle [Off time first)
al: Repeat Cycle [On time first]
FIGURE 5-9. TIME MODES
If the timer is set to an incorrect mode,
NOTE
>
the unit will not operate. Be sure to select
the correct mode for your unit.
1.
Be sure OUT MODE shows in the display. (If it does
not, press SET repeatedly until it does.) Then press
any of the selectors to scroll the display to the
desired mode.
2.
The correct mode for 2415 model units is A.
When the display shows the desired mode, press
ENTER. This exits Programming Mode and returns
to Run Mode.
Advertisement
Table of Contents
