Setting The Range; Setting The Direction; Figure 5-8. Time Direction - MDT CASTLE 2415-UW Service Manual

2415-UW ULTRASONIC CLEANER
5. Adjustments and Calibration
SETTING THE RANGE SETTING THE DIRECTION
μι d UP DOWN
360617-G
360617-F
L
SCROLLING:
: UP
22.. $ (SECONDS) d:DOWN
---,- S [SECONDS]
11717 $ (SECONDS) FIGURE 5-8. TIME DIRECTION
--M-- S (MINUTES: SECONDS]
--,-- M (MINUTES) 1. Be sure UP DOWN shows in the LCD display. (If it
---,- M (MINUTES) does not, press SET repeatedly until it does.) Then
ーーーー M {MINUTES} press any of the selectors to display either:
--H-- M {HOURS: MINUTES]
--_-~- H (HOURS) d—Display will time down from the setpoint to zero
---.- H (HOURS) U—Display will time up from zero to the setpoint
----- H {HOURS}
2. The recommended direction for 2415 model units
FIGURE 5-7. TIME RANGES isd.
3. When the display shows the desired direction, press
1. Be sure 7 RANGE shows in the LCD display. (if it SET. OUT MODE will appear (see Figure 5-9).
does not, press SET repeatedly until it does.) Then
press any of the selectors to scroll the display to the
desired range (see Figure 5-7).
Be sure to watch the decimal point in the
NOTE > run time setpoint display (Figure 5-6,
Пет 11). Do not be confused by the
larger decimal point (Figure 5-6, Item 6).
2. The recommended range for 2415 model units is
_M__8
3. When the display shows the desired range, press
SET. UP DOWN will appear (see Figure 5-8).
350593 5-9