Table of Contents
Advertisement
INSTALLATION
32
Disassembly
Disassembling the Washer and
Dryer
The washer and dryer cannot be disassembled and
installed for use side by side. If it is necessary to
disassemble the appliance in order to move or
reinstall it, follow these instructions.
WARNING
• Protect your hands and arms from sharp edges.
To reduce the risk of injury to persons, adhere to
all industry recommended safety procedures
including the use of long-sleeved gloves and
safety glasses.
NOTE
• Any damage resulting from improper
disassembly/assembly or installation of the
product is not covered by the product warranty.
1
Be sure to unplug the appliance.
2
Loosen screws assembled on the stack bracket
on the back of the appliance.
3
Push open the caps at the left and right sides of
the control panel on the front of the appliance.
Loosen the screws under the caps.
4
Pull the control panel forward to remove it.
5
Disconnect the wire harnesses from the
washer
and dryer
a
CAUTION
• Always ground yourself before touching the PCB
or wiring. Discharge of static electricity may
cause product malfunction.
NOTE
• Tuck the wire harnesses to the side to avoid
pinching them.
to the control panel.
b
Advertisement
Table of Contents
