Weider POWERGUIDE X4.2 Owner's Manual page 15

PAGE 11 — WEIDER SPORTING GOODS
STEP 10 SQUAT ARM ASSEMBLY
PARTMAME |а
42 I ROUND PLASTIC COVERCAP | 1 |
ss 414" ROUND PLASTIC INSERT CAP | 2 |
46 1" ROUND PLASTIC NSERTCAP | 1 |
[i
224:
БАСЫН
C] Press 1 1/4" ROUND PLASTIC INSERT CAPS (85) into the Handle
Bar ends of the SQUAT ARM (21). |
(0 Press а 1 1/4" SQUARE PLASTIC INSERT САР (123) into (ле
Welded Stopper Tube on the SQUAT ARM (21).
C] Press a 1" ROUND PLASTIC INSERT САР (86) into the shorter side
of the Welded Metal Tube.
96 1 1/2" SQUARE PIVOT BUSHING
97 1" SPRING RETAINER RING
123 1 1/4" SQUARE PLASTIC INSERT САР
106
WELDED
86 METAL TUBE
/ | 96 96 ^
меер А
AN PER
S Seem 7
B 12375"
85
85
L] Assemble 1 1/2" SQUARE PIVOT BUSHINGS (96) info the ends of the SQUAT ARM (21).
(J slide the SQUAT ARM (21) onto the Welded Metal Tube on the REAR UPRIGHT (3).
LJ Using a 1" ROUND PLASTIC COVER CAP (82) as an aid, drive a 1" SPRING RETAINER RING (97) onto the Welded
Metal Tube to secure the SQUAT ARM (21) іп place. Note that the teeth in the Spring Retainer Ring are tilted slightly to
one side. The teeth should be away from the Welded Tube as it is driven on. Tap in place with a hammer.
Г 1 Remove the SQUAT STATION DECAL (106) from the backing sheet and attach to the REAR UPRIGHT (3) above the
Welded Metal Tube on the Squat Station side.