Attaching The Sandpaper - Craftsman 320.39589 Operator's Manual

THE LIVE=TOOL iNDiCATOR
LIGHT (Fig. 4}
The sheet sander is equipped
with a live-tool indicator light.
When the tool is plugged into
an electrical supply, the live-
tool indicator light will illuminate
green to remind you that the tool
is plugged in. When the tool is
unplugged, the indicator light will
turn off.
Fig. 4
Live-tool
indicator
ATTACHING THE SANDPAPER
_, WARNING: Always inspect the sandpaper before attaching. Do not use the
paper if it is torn or defective.
The non-adhesive sandpaper clamps to the front and back of the platen.
1. Disconnect the sander from the power source.
WARNING: Failure to unplug the sander could result in accidental starting,
causing possible serious personal injury.
2. Remove any dust or debris
from the platen.
3. The paper clamp levers are
located on each side of the
sander and are locked into slots
on top of the platen (Fig. 5).
4. Raise these two levers "up" and
disengage them from the slots
in the platen. This will release
the tension on the paper
clamps that hold the paper in
position on the underside of the
platen (Fig. 5a).
5. Insert the front end of the
sandpaper approximately 1/2
in. under the front paper clamp.
Front
paper y_
clam_
"_ _ Back
Paper damp
,ow Y,W /
13