Attaching The Accesso_ Holder To Wa I; Changing Sleeves And - Craftsman 113.225705 Owner's Manual

ASsembly(continued)
usingthe dimensions in the figure. Screw them in until
there is al/i6 gap between the Screws and the wall.
..... If secUring to drywall or plaster, toggle bolts will be
: : :required to adequately support the holder.
:2, Slide the slots in the back of the accessory holder over
the. sCrew heads. If the holder is not snug against the
wall, adjust the screws as necessary.
._. 1_314,,-,.-
ii i
(;hanging Sleeves and Drums
Removal and installation of sander sleeves and
drums.
NOTE: The spindle sander is shipped with a 2" diameter
drum, sanding sleeve, and a 2-3/8" diameter spacer ring
insert installed.
WARNING: To avoid injury from accidental start-
ing, always turn switch "OFF" and remove switch
key before removing or replacing the spacer ring
inserts, sleeves and drums.
Changing and installing sanding sleeves larger than
1/2" diameter.
t. Hand support sleeve and rubber drum on spindle while
loosening the 5/16-24" hex nut using the wrench .sup-
(_--,_-_- 5t16-24 Nut
__ : : Washer
Sanding Sleeve
Sanding Drum
(_-----_ Spacer Ring Insert
plied as shown. __%
2. Remove the hex nut, upper spindle washer, sanding _ Lower Spindle
sleeve, spacer ring insert, and rubber sleeve.
3. Remove the lower spindle washer and clean sawdust
from around the spindle,
NOTE: This cleaning is highly recommended when-
ever a wet!dry vac is not connected to the dust collec-
tion port and used with sander. A dust buildup may
cause the oscillating motion to stop when the sawdust
port is blocked.
4. Slide the lower spindle washer onto the spindle
(grooved side down). The lower spindle washer is
used with all drums and sleeves.
5, Position spacer ring insert in the table recess. (See
recommended spacer ring insert selection area from
table on page 1 1).
6. Place desired sanding sleeve on correct drum and
slide them on the spindle. NOTE: It the drum is difficult
to slide over the spindle, apply talcum powder to the
spindle.
7. Install the correct upper spindle washer and 5/1 6-24"
nut and tighten the hex nut with wrench while grasping
the sleeve. Do not overtighten.
8. Remove the wrench and return it to the storage area
on the holder.
9. Plug line cord in the power source and install the key.
SANOING
SLEEVE
SPAC ER
R| NG
OPENING
SPACER:
RING
TO
LOOSEN
10