How To Change The Fader Unit - Vestax PMC-05ProSL VCA User Manual

ページ 14

HOW TO CHANGE THE FADER UNIT

■How to remove a top panel
①As shown in fig-a, please remove the knob of INPUT
LEVEL volume,CROSS FADER volume, MONITOR-
e.
LEVEL volume, C.F.MONITOR volume, and LEVEL /
PLAY volume.(A total of six pieces)
②As shown in fig-a, please use a plus screwdriver (size:
No.1), and remove the screw of four points which is
fixing the top panel.
③As shown in fig-b, please remove the screw of two
points which is fixing the fader panel, and raise
upwards the whole fader unit, after removing a top
panel.
④Please pull and remove the connector which has
connected the main part side with the fader unit. (Be
careful not to bend the pin of a connector in this case)
⑤Remove the fader knob of new fader unit.
⑥Attach multi-cable connector to new fader unit.
⑦Position the new fader unit carefully and secure with
screws.
fig.a
he
TOP PANEL
MAIN PANEL
ou
if
is
a
it
fig.c
Insert the
ng
multi-cable
connecter
DRIVER
KNOB
Set switch to "PMC" position
fig.b
fig.d
-13-
DRIVER