How To Change The Fader Unit - Vestax PMC-007 Owner's Manual

HOW TO CHANGE THE FADER UNIT

Exchanging a ReX Fader Unit
The ReX (Rapid Exchange) fader system has been
designed to allow users to quickly exchange faders. By
following and adhering to the following directions and
advice you will be able to safely and easily exchange ReX
type faders. In the event that the ReX unit itself or the ReX
exchange system is damaged in anyway do not operate this
mixer before consulting your local Vestax service center.
Note
Leaving the mixer unit with the top panel open and
any fader cables unconnected could result in some
damage. For this reason it is best to have all
replacement faders ready for installation so as to
avoid any unnecessary damage or delay.
q Remove all knobs from the Battle Panel as illustrated.
w Release the top panel as illustrated.
e Caution should be exercised when opening the top panel so as
to avoid any unnecessary damage to the panel unit or release
system.
r A ReX fader is easily removed by simply applying
simultaneous pressure to the clips located at either end of the Fader
f i g a
f i g b
mounting unit, once release pull the fader upwards carefully.
t Remove the cable connector from the fader unit carefully.
y Exchange the fader unit making sure to reconnect the
cable connector unit correctly.
u Click the ReX fader unit back in place. Check that the
unit is secure by gently pushing on the fader unit.
i Lower the Battle Panel as illustrated taking care to realign
the fader slots and fader forks properly. This panel will
not close if realigned incorrectly.
o Check to ensure that the panel is correctly in place and then
replace all knobs. You have now successfully exchanged
your ReX fader unit.
f i g c
f i g d
f i g e
9